Other Functions; Setting A Scan Type - Icom IC-F29DR2 Operating Instructions Manual

Previous view
6
Section

Setting a scan type

You can set to whether the transceiver scans all
channels across the zone (All), or scans channels in a
selected zone (Zone).
NOTE: Turn ON the Beep function (p. 7) before
you start setting a scan type.
1. Rotate [VOL] to turn OFF the transceiver.
2. Set [Rotary Selector] to Channel 16.
3. While holding down [PTT], rotate [VOL] to turn ON
the transceiver to set a scan type and confirm the
number of beeps.
z  I fyouwanttosetto"All,"confirmabeepandan
opening beep sound when you do step 3.
If 2 beeps and an opening beeps sound, turn off
the transceiver, then do step 3 again.
z  I fyouwanttosetto"Zone,"confirm2beeps
and an opening beep sound when you do step
3.
If a beep and an opening beep sound, turn off
the transceiver, then do step 3 again.
4. Rotate [VOL] to turn OFF the transceiver, then
turn ON again to save the setting.
To start a scan, push the key assigned the scan
function.

OTHER FUNCTIONS

[Rotary Selector]
[PTT]
19
[VOL]