Settings; Setting The Beep Function - Icom IC-F29DR2 Operating Instructions Manual

Previous view
4
Section

Setting the Beep function

You can turn the Beep function ON or OFF.
NOTE: Turn ON the Beep function when you set the
beep and announcement level, Call-Ring ringer, ringer
level, microphone gain, squelch level, VOX function,
or VOX gain to check the current level setting by
counting or hearing beeps. (pp. 8 ~ 14)
1. Rotate [VOL] to turn OFF the transceiver.
2. Set [Rotary Selector] to any channel other than
Channel 16.
3. While holding down [Lower], rotate [VOL] to
turn ON the transceiver to enter the Beep Level
Adjustment mode.
• An opening beep sounds and the selected channel
number will be announced.
4. Push [Lower] to turn the Beep function ON or
OFF.
• When a beep sounds after pushing [Lower], the Beep
function is ON.
• When no beep sounds after pushing [Lower], the Beep
function is OFF.
L The transceiver stores the setting every time you
change it.
L If desired, push [Upper] to adjust the beep level. See
page 8 for details.
5. Rotate [VOL] to turn OFF the transceiver and exit
the Beep Level Adjustment mode.

SETTINGS

[Rotary Selector]
[Upper]
[Lower]
7
[VOL]