Power Save Modes; Locking And Unlocking The Front Panel (Executive Mode) - Extron electronics DXP 44 HD 4K PLUS Setup Manual

Saving or Recalling a Preset
A preset is a complete map of all input and output connections. The current configuration (0) can be saved as a preset in any one
of 16 preset memory slots. Preset locations are assigned to the input and output buttons, and each switcher has as many presets
available from the front panel as it has input and output buttons. In addition, all presets can be saved and recalled from the PCS
software and by SIS commands. When a preset is retrieved from memory, it becomes the current configuration.
NOTE:
Ensure that power save mode 2 (all front panel functions are disabled except for mode 1 selection) is not enabled.
To save a preset, press and hold the Preset button until it blinks. To recall a preset, press and release the Preset button.
1.
PRESET
Save a
preset
PRESET
Recall a
preset
• All Input and Output button LEDs with assigned presets light red.
• The current preset is overwritten if you select a previously saved
preset.
INPUTS
1 2
5 6
Figure 7. Saving or Recalling a Preset
NOTE:
Although the DXP 44, 84, and 88 have only enough front
panel buttons for presets 1 through 16 (8 inputs and 8 outputs),
presets 17 through 32 can be saved and recalled via SIS and PCS.
Press the desired input or output button.
2.
Press the Enter button.
3.

Power Save Modes

Power save modes are selectable only by SIS commands. Three modes are available:
• 0 — Normal (full power) operation (default).
• 1 — Disables all functions except RS-232, USB, and IP control, and reduces cooling fan speed. This mode is cancelled if a
power is cycled, any front panel buttons are pressed, PCS is opened, or any SIS commands are sent via RS-232, USB, or IP.
• 2 — Locks the front panel, reduces cooling fan speed, and disables all functions except RS-232, USB, PCS, and IP control.
This mode can be cancelled only by entering the SIS command
NOTE:
The green front panel Video LED blinks while the DXP is in power save mode 1 or 2.

Locking and Unlocking the Front Panel (Executive Mode)

The DXP switcher has three levels of security lock that limit the operation of the switcher from the front panel:
• Lock mode 0 — The front panel is completely unlocked.
• Lock mode 1 — All front panel functions are locked (except for setting lock mode 2). Some functions can be viewed.
• Lock mode 2 — Basic functions are unlocked. Advanced functions, such as setting video and audio mute, are locked and
can be viewed only (see the table below). The switcher is shipped from the factory in this mode.
Basic Functions
• Making ties
• Saving and recalling presets
• Changing lock modes
PRESET
Press and hold.
2 seconds
PRESET
Press and release.
OUTPUTS
3 4 1
7 8 5
The LED blinks red to indicate that this
preset is selected to save or recall.
1
Advanced Functions
• Setting video and audio output mutes
• Setting the RS-232 port baud rate
Preset LED blinks.
Preset LED lights.
2 3 4
6 7 8
ENTER The Enter LED blinks green
to indicate the need to
activate the save or recall.
E }
0 PSAV or opening PCS.
7