Operation; Creating Ties - Extron electronics DXP 44 HD 4K PLUS Setup Manual

DXP HD 4K PLUS Series • Setup Guide (Continued)
I/O button — Has
E
two LEDs to its right: a
green Video LED and a
red Audio LED. Press
the I/O button to
toggle between video
(green LED lights) and
audio (red LED lights).
NOTE: In addition, if the unit is in power save mode 1, pressing any of the front panel buttons cancels this mode (see
Power Save Modes
F Audio and Video LEDs — These two LEDs are located to the right of the I/O button and light to indicate whether the
selected input or output is audio or video. The Video LED lights green when the I/O button is pressed to toggle to video. The
Audio LED lights red when audio is selected.
Signal LEDs — The DXP has a green Signal LED for each input. Each LED lights when a signal (TMDS clock activity) is
G
present on the input.
HDCP LEDs — The DXP has a green HDCP LED for each input. Each of these LEDs lights if the source connected to its
H
input is HDCP encrypted.

Operation

Creating Ties

NOTES:
• "Tie" is an input-to-output connection.
• "Set of ties" is an input tied to two or more outputs. (An output can never be tied to more than one input.)
• "Configuration" is one or more ties, one or more sets of ties, or a combination.
• Audio ties can be made only with de-embedded audio (audio output 2 only).
• If power save mode 2 is enabled (all front panel functions are disabled except for mode 1 selection), you cannot use the
front panel to make ties.
Press and release the Esc button to clear any input button, output button, or control button indicators that may be lit (or
1.
whose LED might be lit).
Press I/O button to
select audio or video.
Figure 6. Selecting an Output for the Tie
Press the I/O button to select video or audio.
2.
NOTE: You cannot select both audio and video for a tie at the same time. You must repeat the tie process for each type
of tie (audio and video) for the desired input and output. For example, first create a video tie between an input and
output, then create an audio tie for the same input and output.
Press an input button. The LED lights to indicate the selection.
3.
Press the output buttons to which the input is to be tied (see the
4.
illustration at right).
Press the Enter button. All button indicators become unlit.
5.
6
Front Panel Button Functions
Primary Function
• Select the signal type, audio or video, for
the input or output.
• Select audio or video for the configuration
that is being viewed.
on the next page).
VIDEO
I/O
Lights green when video is selected.
I/O
AUDIO
Lights red when audio is selected.
Secondary Functions
• Select the baud rate for the Remote
RS-232 port.
• Set the front panel lock mode (executive
mode).
• View the video or audio mute status of
the selected input or output.
• Video LED blinks to indicate that the unit
is in power save mode.
The LED lights to
indicate the selection.
1
NOTE: Analog output 1 and S/PDIF output 1 are always
connected to the video input tied to them. Analog output 2
and S/PDIF output 2 can be broken away (untied).
Green indicates a video-only tie.
Red indicates an audio-only tie (de-embedded audio outputs 1 and 2).
1
1
ENTER
Blinking green indicates the
need to confirm the change.