Viewing Ties - Extron electronics DXP 44 HD 4K PLUS Setup Manual

DXP HD 4K PLUS Series • Setup Guide (Continued)
Selecting front panel lock mode 2 or toggling between lock modes 2 and 0
NOTES:
• If the switcher is in lock mode 0 or 1, this procedure selects mode 2.
• If the switcher is in lock mode 2, this procedure selects mode 0 (unlocks
the switcher).
• Toggle the front panel lock on and off by pressing and holding the Enter, I/O,
and Esc buttons simultaneously until the following LEDs blink twice
(approximately 3 seconds).
If the DXP is now in lock mode 2, the Esc, Video, and Audio LEDs blink
•
twice.
If the DXP is now in lock mode 0, the Video and Audio LEDs blink twice.
•
Selecting front panel lock mode 2 or toggling between lock modes 2 and 1
NOTES:
• If the switcher is in lock mode 1, this procedure selects mode 2.
• If the switcher is in lock mode 2, this selects mode 1 (locks all switcher functions except selecting
mode 2).
• Toggle the lock on and off by pressing and holding the Esc and I/O buttons until the following buttons
blink twice (approximately 3 seconds).
If the DXP is now in lock mode 2, the Esc, Video, and Audio buttons or LEDs blink twice.
•
If the DXP is now in lock mode 1, the Video and Audio buttons or LEDs blink twice.
•
NOTE:
To switch from lock mode 1 (front panel is completely locked) to lock mode 0 (front panel is
unlocked), you must first switch to mode 2, then from mode 2 to mode 0.

Viewing Ties

Several methods are available for viewing which inputs and outputs are actively connected (tie configuration) and which outputs
are muted, at the same time.
NOTE:
Before beginning to view ties and mutes, press the Esc button to clear any pending ties. Ensure the unit is not in
power save mode
For the I/O button, the Video selection routes HDMI signals from any of the inputs to any of the HDMI outputs. The Audio
selection routes the de-embedded audio from any of the HDMI inputs to any pair of S/PDIF and analog audio outputs.
NOTE:
Each S/PDIF output is paired with the analog output with the same number and cannot be selected separately,
although they can be individually muted. Any de-embedded audio signal sent from an input goes to both the S/PDIF and
analog output with which it is paired.
Press the I/O button to select audio or video (selection of both simultaneously is not supported on these models).
1.
Select the input or output ties to view:
2.
To view ties to an input: Press the desired input button. The button LEDs light for all outputs that are tied to that input
•
(green for video ties or red for audio ties).
NOTE:
If you press an output button while an input is selected for viewing, the output LED blinks to indicate a
pending tie. Press Esc to cancel the tie or Enter to add the tie to the selected input.
To view ties to an output: Press the desired output button. The buttons LEDs for the tied input and all other outputs
•
tied to that input light.
To view all untied outputs: Press an untied output button while another output is selected. All untied output LEDs
•
light.
To turn off all lit LEDs, press the Esc button, or wait until the lit button LEDs time out (approximately 15 seconds).
3.
8
2.
Press and hold simultaneously.
ENTER ESC
I/O
3 seconds
VIDEO
ESC I/O
The LEDs blink twice.
AUDIO
Release the buttons.
Press and hold
simultaneously.
ESC
3 seconds
I/O
The LEDs blink twice.
Release the buttons.
VIDEO
AUDIO
I/O
VIDEO
AUDIO