Front Panel Features - Extron electronics DXP 44 HD 4K PLUS Setup Manual

Front Panel Features

The front panel buttons of the DXP 88 series are grouped into two sets, with the input and output buttons located on the left
side of the control panel and the control buttons on the right side. The front panel buttons have multiple primary and secondary
functions. For more details on these functions, see the DXP HD 4K PLUS user guide, available at www.extron.com. Each button
has an LED beside it. These bicolor LEDs light green when video is selected and red when audio is selected.
A A B B
E
INPUTS
1 2 3
5 6 7
CONFIG
Config port
A
Input buttons
B
Figure 5. DXP 88 HD 4K PLUS Front Panel
NOTE:
Figure 5 shows the front panel of a DXP 88 HD 4K PLUS. Although the DXP 44 and 84 also have eight input and
eight output buttons, not all these buttons are functional:
• DXP 44: Only input and output buttons 1 through 4 are functional, except for creating and recalling presets.
• DXP 84: Only output buttons 1 through 4 are functional, except for creating and recalling presets.
Config port — This USB mini-B port serves a similar communications function to the rear panel
A
Remote port, but is easier to access than the rear port after the matrix switcher has been installed and
cabled. Use a USB type A to mini B cable to connect this port to a USB connector on the computer to
enable SIS commands to be sent from the computer, connection to the PCS configuration software, and
uploading firmware.
Input buttons
B
C Output buttons
D Control buttons
Enter button
Preset button
Esc button
C C
OUTPUTS
4 1 2 3 4
8 5 6 7 8
Output buttons
C
Control buttons
D
Front Panel Button Functions
Primary Function
• Select an input.
• Select output or outputs.
• Save changes made on the front panel.
• Indicate that a potential tie has been
created but not saved.
• Indicate that a global preset has been
selected to be saved or recalled but the
preset action has not been completed.
• Place the switcher in preset saving mode
to save a configuration as a preset, and
in preset recalling mode to activate a
previously-defined preset.
• Indicate when preset saving mode is active
(blinks) and when preset recalling mode is
active (lights steadily).
• Cancel operations or selections in progress
and resets the front panel button indicators.
• Indicate that the escape function has been
activated (blinks once).
NOTE:
The Esc button does not reset the current configuration or any presets.
D D E E F F
VIDEO
ENTER PRESET ESC I/O
SIGNAL
1
HDCP
AUDIO
I/O button
E
Audio and Video LEDs
F
Secondary Functions
•
•
•
•
•
•
•
•
•
•
•
G G
DXP HD 4K PLUS SERIES
INPUTS
D I G I TA L C R O S S P O I N T M AT R I X S W I T C H E R
2 3 4 5 6 7 8
H H
Signal LEDs
G
HDCP LEDs
H
E
Save and recall presets.
View ties.
Save and recall presets.
View ties.
Mute video and audio.
View HDMI audio signals de-embedded
from input.
Select the baud rate for the Remote
RS-232 port.
Set the front panel lock mode (executive
mode).
Select the baud rate for the Remote
RS-232 port.
Select the baud rate for the Remote
RS-232 port.
Set the front panel lock mode
1
A A
5
CONFIG
5