Extron electronics DXP 44 HD 4K PLUS Setup Manual page 9

Muting an Output from the Front Panel
NOTES:
• Mutes are protected when front panel lock mode 2 is selected. You can view the status of the output (muted or unmuted)
in lock mode 2 but you cannot change it from the front panel.
• To enable changes to the mute settings, set the lock mode to 0.
• Ensure the unit is not in power save mode 2.
Locking and Unlocking the Front Panel (Executive Mode)
See
Press Esc to clear any button selections or incomplete ties.
1.
Press the I/O button to toggle to your desired selection, Video (green LED lights) or Audio (red LED lights).
2.
Press the button for the output to be muted, and hold it until its LED begins to blink (approximately 2 seconds). The LED
3.
continues to blink until unmuted.
To unmute an output, press and hold the button whose LED is blinking until the blinking stops (approximately 2 seconds).
NOTE:
If you want to mute an output, but accidentally press an input button prior to pressing and holding the desired output,
this voids the output muting process and activates the tie process.
Viewing the mute configuration
You can view the mute configuration whether the outputs were muted using the front panel, SIS commands, or the PCS software.
To view which outputs are currently muted:
Press the Esc button.
1.
Select the type of signal to view (see "Muting an Output from the Front Panel," step 3).
2.
Press the button for the output to be viewed.
3.
If only the audio is muted
• The output button or LED blinks red.
• The video button or LED lights steadily green.
Selecting the Remote RS-232 Port Baud Rate
NOTES:
• The serial port baud rate setting is protected when front panel lock mode 2 is selected. You can view the setting in lock
mode 2 but you cannot change it from the front panel (see
To enable changes to the baud rate setting, set the lock mode to 0. Ensure the unit is not in
•
To set the baud rate from the front panel:
Simultaneously press and hold all Control buttons (Enter, Preset, and Esc) until all of the Control button LEDs light
1.
(approximately 2 seconds). The Control button LED representing the current baud rate blinks steadily.
Press the appropriate Control button to select the desired baud rate: Enter = 9600, Preset = 19200, and Esc = 115200.
2.
The LED of the selected button blinks.
Press and hold simultaneously.
PRESET
ENTER
The Control LED that continues blinking indicates the baud rate as follows:
Enter – 9600 Preset – 19200
Figure 8. RS-232 Baud Rate Display
Release the Control buttons.
3.
Press and release an output button to exit the serial port configuration mode.
4.
ESC ENTER
2 seconds
All Control LEDs light with one blinking.
Esc – 115200
Power Save Modes
and
If only the video is muted
• The output button or LED blinks green.
• The output button or LED lights steadily red.
Locking and Unlocking the Front Panel [Executive
ESC
PRESET
on page 7 for more information.
Mode].)
power save mode 2.
9