Accessing The Web Page - Extron electronics DXP 44 HD 4K PLUS Setup Manual

Accessing the Web Page

The embedded DXP HD 4K PLUS web page enables you to monitor and adjust certain settings of the DXP through its Ethernet
port, connected via a LAN or WAN and using a web browser such as Microsoft
page is always available and cannot be erased or overwritten.
NOTE:
If your Ethernet connection to the DXP is unstable, try turning off the proxy server in your Web browser. To do this in
Microsoft Internet Explorer, click Tools > Internet Options > Connections > LAN Settings, clear the Use a proxy
server... checkbox, then click OK.
In the Address field of your Web browser, enter the IP address of your unit. The default address for most Extron products
1.
is 192.168.254.254. You can change this address using SIS commands, the PCS configuration software, and the
DXP HD 4K PLUS Series web page (see the DXP 4K HD PLUS User Guide, available at www.extron.com, for instructions).
Press the <Enter> key. The DXP checks to see if the web page is password protected.
2.
If the unit is not password protected, the web page opens.
•
If the unit is password protected, the Authentication Required dialog box opens.
•
If an administrator or user password is required, enter the user name (admin, by default) in the User Name field and the
3.
password in the Password field. Click Log In. The DXP HD 4K PLUS web page contains the following panels:
Input Status — Displays the signal type and status of each input (see figure 10,
•
Output Status — Displays the signal and display type of each output (
•
Communication Settings — Displays the IP and gateway addresses and the subnet mask of the DXP, as well as
•
DHCP status and MAC (hardware) address (
to access editable fields.
Device Info — Displays information about the DXP model, including the model type, part number, firmware version, and
•
so on ( ).
4
To assign a new name to the device, click the Edit button (
•
To update the firmware, click the Update button (
•
Date/Time Settings — Lets you view and edit the date and time on the DXP (
•
time on the DXP to match that of the computer to which it is connected. Click Set Manually to access editable date
and time fields.
Passwords — Click the Set button to enter a new password or change the current one (
•
Configure This Device — This panel contains a link to the Extron website, from which you can download the PCS
•
configuration software (
Figure 10. Device Info Panel on a DXP 88 Web Page
For details on the DXP HD 4K PLUS web page, see the DXP HD 4K PLUS Series User Guide, available at www.extron.com.
© 2018 Extron Electronics All rights reserved. All trademarks mentioned are the property of their respective owners.
). To edit these settings (except the MAC address), click the Edit button
3
9 ).
Internet Explorer
®
1
).
2
) in this panel.
5
).
6
). Click Sync to PC to set the date and
7
www.extron.com
. This factory-installed Web
®
).
8 ).
68-2939-50 Rev. A
03 18