Table of Contents
Advertisement
WLAN module
Description
Intel Dual Band Wireless-AC 7265 NV
Intel Dual Band Wireless-AC 8260 + Bluetooth 4.0
Intel Dual Band Wireless-AC 8260 + Bluetooth 4.0 (non-vPro)
The WLAN module is secured with one Phillips screw and has two connected antennas.
To remove the WLAN module:
1.
Remove the access panel
2.
Remove the Base Module
3.
Locate the WLAN module on the system board.
4.
Disconnect both antenna cables from the WLAN module (1).
NOTE:
cables.
5.
Remove the Phillips screw (2) that secures the module to the system board.
32
Chapter 4 Removal and replacement procedures – HP Elite Slice Base Module
(Access panel on page
(Base Module on page
You may need to use a small tool, such as tweezers, to disconnect and connect the antenna
21).
30).
Advertisement
Table of Contents
