Download  Print this page

Removal And Replacement Procedures - Hp Elite Slice Base Module; Access Panel - HP Elite Slice G2 Maintenance And Service Manual

Skype room system.
Hide thumbs

Advertisement

4
Removal and replacement procedures – HP
Elite Slice Base Module
Adherence to the procedures and precautions described in this chapter is essential for proper service. After
completing all necessary removal and replacement procedures, run the Diagnostics utility to verify that all
components operate properly.
NOTE:
Not all features listed in this guide are available on all computers.
NOTE:
HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.

Access panel

The Elite Slice G2 access panel must be removed to access internal components (see
on page
8).
1.
Remove the Elite Slice G2 from any additional modules.
2.
Place the computer upside down on a flat surface covered with a soft cloth to protect the computer from
scratches or other damage.
3.
Loosen the four captive screws securing the access panel, and lift the panel off the computer.
To replace the access panel, reverse the removal procedures.
Removing modules
Access panel
21

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: