Table of Contents
Advertisement
Removing modules
CAUTION:
source.
Modules cannot be "hot-plugged" or "hot-swapped."
Modules must be removed one at a time, starting at the bottom. Removing the Base Module exposes the
release latch of the module above it.
1.
Remove/disengage the security cable, if one is attached.
2.
Remove all removable media, such as USB flash drives.
3.
Turn off the Elite Slice G2 properly through the operating system, and then turn off any external devices.
4.
Disconnect the AC power cord from the Elite Slice G2 and disconnect any external devices.
5.
If the VESA plate is connected, slide the quick release latch on the back of the VESA plate to the unlocked
position and lift the module stack off the VESA plate.
6.
Beginning at the bottom, remove additional modules by pressing the release latch (1) on the underside
of each module until it releases the module (2) above it.
8
Chapter 1 Product features
Before disconnecting modules, turn off the Elite Slice G2 and disconnect it from any AC power
Advertisement
Table of Contents
