Table of Contents
Advertisement
Connecting modules
Connecting modules
CAUTION:
source.
Modules cannot be "hot-plugged" or "hot-swapped."
1.
Remove/disengage the security cable, if one is attached.
2.
Remove all removable media, such as USB flash drives.
3.
Turn off the Elite Slice G2 properly through the operating system, and then turn off any external devices.
4.
Disconnect the AC power cord from the Elite Slice G2 and disconnect any external devices.
5.
If the VESA plate is connected, slide the quick release latch to the unlocked position and remove the
VESA plate.
6.
Align the module connection port on the underside of the Elite Slice G2 with the module expansion
connector on the new module and press the computer down firmly.
You should hear a quiet click when the modules lock together. The module locks into place and hides the
release latch of the module above it.
Repeat until all modules have been connected.
Connecting the optional Slice VESA plate
If the VESA plate is connected, the Elite Slice G2 can be mounted onto a table.
CAUTION:
source.
1.
Slide the quick release latch on the VESA plate to the unlocked position. Position the connected modules
over the VESA plate.
The VESA plate does not have a module expansion connector. Be sure that the ports of the Elite Slice G2
and the quick release latch and security cable slot of the VESA plate are all on the same side.
6
Chapter 1 Product features
Before connecting modules, turn off the Elite Slice G2 and disconnect it from any AC power
Before connecting the VESA plate, turn off the Elite Slice G2 and disconnect it from any AC power
Advertisement
Table of Contents
