Download  Print this page

Ambient Sensor - HP Elite Slice G2 Maintenance And Service Manual

Skype room system.
Hide thumbs

Advertisement

Ambient sensor

The ambient sensor is located on the system board.
To remove the ambient sensor:
1.
Remove the access panel
2.
Remove the Base Module
3.
Disconnect the cable from the system board connector (1).
4.
Remove the sensor from the holder attached to the system board (2).
To install the ambient sensor, reverse the removal procedures.
36
Chapter 4 Removal and replacement procedures – HP Elite Slice Base Module
(Access panel on page
21).
(Base Module on page
30).

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: