Table of Contents
Advertisement
4.
Remove the screws (1) securing the solid-state drive in the cage and lift the solid-state drive (2) out of
the cage.
5.
Position the new solid-state drive over the drive cage with the solid-state drive connectors at the end
with the thermal patch and the circuit board side facing the closed side of the drive cage.
6.
Set the new solid-state drive (1) into the cage. Be sure the label side of the solid-state drive is visible.
7.
Fasten the four screws (2) to secure the solid-state drive in the cage.
8.
Connect the power-and-data cable (1) to the solid-state drive.
9.
Set the drive cage (2) in the chassis. Be sure that the solid-state drive connectors are facing the back of
the chassis.
2.5-inch, solid-state drive (SSD)
27
Advertisement
Table of Contents
