Failed Devices (Failed Nodes); Important Notes About Z-Wave Devices - Honeywell Lyric LCP300-L User Reference Manual

All Devices Off All Devices Off
All Devices Off All Devices Off
Press to manually turn off all Z-Wave devices. Note
mode.
All Devices On All Devices On All Devices On All Devices On
Press to manually turn on all Z-Wave devices. NOTE:
mode.
Failed Devices
When the system tries to operate a Z-Wave device that has no AC power or other problems,
it is identified as a Failed Device
detect the failure.
Failed Z-Wave devices are also indicated by a
Management screen or the
To view Failed Devices: To view Failed Devices: To view Failed Devices: To view Failed Devices:
1. On the Z-Wave Device Management screen, select View Failed Devices
OR press the Down arrow ( OR
OR OR
2. The device's information is displayed. If multiple devices are listed, use the up and
down arrows at right to view the entire list.
NOTE: When troubleshooting, first make sure that power has been restored. NOTE
NOTE NOTE
3. If a device is defective or otherwise unavailable, use the Fix All
Press Fix All Fix All and "This will delete all failed nodes Fix All Fix All
Devices deleted with Fix All must be added to the system again. See
Devices Devices (Include) (Include).
Devices (Include) Devices (Include)
To To Replace To To Replace Failed Devices: Replace Replace Failed Devices: Failed Devices: Failed Devices:
1. From the Z-Wave Device Management screen, press the Down arrow (
2. Press Replace Replace Failed Devices
Replace Replace
3. When a failed device is highlighted and the "Replace
displays "Entering Inclusion Mode. Please Wait...". Next, "Ready to include device,
select the function button on the device" appears.
4. W W ithin one minute ithin one minute press the device's Function button or activate the switch, as
W W ithin one minute ithin one minute
applicable. If the module has been successfully enrolled, the panel displays "Device
Found! Please Wait". After successfully including a device, the device is removed from
the failed devices list.

Important Notes About Z-Wave Devices

WARNING: NOT FOR USE WITH MEDICAL OR LIFE SUPPORT EQUIPMENT! WARNING: NOT FOR USE WITH MEDICAL OR LIFE SUPPORT EQUIPMENT!
WARNING: NOT FOR USE WITH MEDICAL OR LIFE SUPPORT EQUIPMENT! WARNING: NOT FOR USE WITH MEDICAL OR LIFE SUPPORT EQUIPMENT!
Z-Wave enabled devices should never be used to supply power to, or control the On/Off
status of medical and/or life support equipment.
Wireless Range Wireless Range
Wireless Range Wireless Range
This device complies with the Z-Wave
distances of 328 feet (100 meters). Actual performance in a home depends on the number of
walls between the controller and the destination device, the type of construction and the
number of Z-Wave enabled devices installed in the control network.
Note that Z-Wave home control networks are designed to work properly alongside wireless Note Note Note
security sensors, Wi-Fi, Bluetooth and other wireless devices. Some 900MHz wireless devices
such as baby cams, wireless video devices and older cordless phones may cause interference
and limit Z-Wave functionality.
(Failed Nodes)
Failed Device. The system may take up to a minute after the operation to Failed Device Failed Device
symbol appears in gray on the Home screen.
), Tools
This will delete all failed nodes" appears. Press Yes This will delete all failed nodes This will delete all failed nodes
Failed Devices.
Failed Devices Failed Devices
®
standard of open-air, line of sight transmission
Note that some thermostats will enter Setback
Note Note
NOTE: Some thermostats will exit Setback
NOTE: NOTE:
symbol on the Z-Wave Device
View Failed Devices View Failed Devices View Failed Devices
Tools and then View Failed Devices View Failed Devices.
Tools Tools View Failed Devices View Failed Devices
Replace" button is selected, the screen Replace Replace
30
Fix All option.
Fix All Fix All
Yes to confirm. Yes Yes
Adding Z- - - - Wave Adding Z Wave
Adding Z Adding Z Wave Wave
), then Tools Tools. . . . Tools Tools