Security Features - Honeywell Lyric LCP300-L User Reference Manual

Security Features

NOTES: S: S: S: • • • • For the Lyric Gateway to report alarms over the internet, your Wi-Fi network MUST NOTE NOTE NOTE
have power at all times.
• You must arm your security system in order for it to sound alarms.
Sensors and Your system's sensors are assigned to numbered zones
Zones your home. For example, the sensor on an entry/exit door might be assigned to Zone
03, a device in a bedroom to Zone 06, and so on.
When alarms or trouble conditions occur, you can find information about the zone
number and a description of the sensor involved using the MyHome Gateway App.
[Home > Security > Tools . Master User Code > Events Home > Security > Tools . Master User Code > Home > Security > Tools . Master User Code > Events Home > Security > Tools . Master User Code > Events
Fire Fire protection is always active when the system is operating normally. An alarm
Protection sounds if a fire condition is detected. See
information about fire protection, smoke detectors and planning emergency exit
routes.
Carbon Carbon monoxide (CO) detectors, if installed, are always active and sound an alarm if a
Monoxide carbon monoxide condition is detected. See
Burglary Gateway provides HOME and AWAY burglary protection.
Protection
HOME mode protects windows and exterior doors, allowing you to move around inside
your home without setting off an alarm. (This mode may be referred to As STAY mode
in Total Connect.)
AWAY mode protects the entire premises, including interior motion detectors, if
present.
Both modes offer an entry delay period that allows you to reenter the home without
setting off an alarm. For long periods such as vacations, the entry delay can be turned
off while arming the system.
Gateway also allows you to Bypass
The system also features C C C C hime
doors and windows while the system is disarmed.
Security A user code is required when arming or disarming and for some other functions.
(User)
When the system is installed, you are asked to choose a personal 4-digit security code,
Codes
known as the "Master User code".
Other users can be added, typically with less control over the system than the Master
User. See
User Code If six invalid user codes are entered, the system locks out additional code entry
Error attempts for 15 minutes. Additional user code entry attempts will not be accepted until
(Keypad the lock out period ends.
Lockout)
NOTE: The system can be Quick Armed while in Lockout mode, but cannot be NOTE
NOTE NOTE
disarmed.
Alarms When there is an Alarm, the system's sounders turn on: Internal sounders on the Gateway
Touchpad Touchpad and any smart devices running the MyHome Gateway Touchpad Touchpad
sirens (if used).
The Gateway Touchpad's status shield and Alert
Gateway App screen indicates Alarm
occurred.
After 15 seconds, the sounder stops temporarily and the system begins voice
announcements of relevant zone information. After the zones are announced, the
system's sounder resumes sounding. Alarm sounds and voice announcements alternate
until the system is disarmed or until alarm bell timeout occurs.
If the system is connected to central monitoring, an alarm message is sent.
To silence the sounder, disarm the system. The zone(s) causing the alarm remain To silence the sounder, disarm the system
To silence the sounder, disarm the system To silence the sounder, disarm the system
displayed on the MyHome Gateway App screen, indicating Memory Of Alarm an Alarm is
held in memory. See
memory.
Audio Alarm Allows your central monitoring station to listen to or talk with individual(s) on the
Verification premises (if programmed to do so).
Bypass selected sensors before arming the system. Bypass Bypass
hime hime mode, which can alert you to the opening of protected hime
Users and Security Users and Security Codes Users and Security Codes Users and Security Codes Codes.
Alarm and shows the zone(s) where the alarm has Alarm Alarm
Clearing a Clearing a Clearing a Clearing an n n n Emergency Emergency Alarm Emergency Emergency
8
zones that correspond to areas of zones zones
Events]
Fire/CO Alarm System Fire/CO Alarm System Fire/CO Alarm System Fire/CO Alarm System
Fire/CO Alarm System Fire/CO Alarm System
Fire/CO Alarm System Fire/CO Alarm System
MyHome Gateway App; also any externals MyHome Gateway MyHome Gateway
Alert blink red. when open, the MyHome
Alert Alert
Alarm Alarm Alarm for more about clearing alarm
for important
for more information.
Gateway Gateway Gateway