Testing Your System; Testing Sensors (Walk Test) - Honeywell Lyric LCP300-L User Reference Manual

Before testing, the system should be disarmed and all protected doors and windows closed. The
Home button should show green. Home
Home Home
No alarm messages are sent to your alarm monitoring company during these tests.
Press Tools Tools and enter the 4-digit Master User code. Press Advanced Tools Tools
Testing Sensors
Home > Security > Tools > Advanced > Walk Test Home > Security > Home > Security > Home > Security >
Start by pressing Walk Test
The Gateway's internal sounder loudly sounds and Walk Test
Gateway then beeps every 30 seconds as a reminder that the system is in Test mode.
Note that Walk Test mode automatically quits after 4 hours.
Doors and Windows Doors and Windows Doors and Windows Doors and Windows
Motion Sensors Motion Sensors Motion Sensors Motion Sensors
Fire/Carbon Monoxide Fire/Carbon Monoxide Fire/Carbon Monoxide Fire/Carbon Monoxide
sensors sensors
sensors sensors
When testing smoke detectors, keep the Lyric Gateway in test mode for at at at at
least one minute (60 seconds) least one minute (60 seconds) after testing the detector to avoid sending least one minute (60 seconds) least one minute (60 seconds)
unwanted alarm messages to your central station monitoring company.
If there is a problem with any sensor (no confirming sounds, no display), notify your service
company.
When all sensors have been checked (and doors and windows closed), no zone identification
numbers should be displayed.
Finish Finish by pressing Home Finish Finish

Testing Your System

NOTE: TESTING SHOUL NOTE NOTE NOTE TESTING SHOUL TESTING SHOUL TESTING SHOULD BE PERFORMED WEEKLY.
(Walk Test)
Tools > Advanced > Walk Test Tools > Advanced > Walk Test Tools > Advanced > Walk Test
Walk Test.
Walk Test Walk Test
Open each protected door and window in turn and listen for three
beeps from the Gateway. If programmed to do so, each zone's voice
descriptor is heard. Identification of protection points with problems
should appear on the MyHome Gateway App screen. Notifications of
problem zones clear when the door or window is closed.
Walk in front of each sensor and listen for three beeps and/or voice
descriptors.
The device's identification should appear on the display when it is
activated. The display clears when no motion is detected.
NOTE: If wireless motion detectors are in use, there is a 3-minute NOTE
NOTE NOTE
delay between activations, which helps preserve battery life.
Follow the manufacturer's instructions to test these devices. When a
device is activated, its identification should appear on the MyHome
Gateway App screen.
Home and entering the Master User code. Home Home
D BE PERFORMED WEEKLY. D BE PERFORMED WEEKLY. D BE PERFORMED WEEKLY.
Advanced. Advanced Advanced
Walk Test – – – – Home to Quit Walk Test Walk Test
IMPORTANT IMPORTANT IMPORTANT IMPORTANT
48
Home to Quit appears. The Home to Quit Home to Quit