Honeywell Lyric LCP300-L User Reference Manual page 51

5. Disconnect the battery pack from the battery receptacle, raise the battery retainer and
remove the battery pack from the battery compartment.
6. Install the new battery pack in the battery compartment and secure with the battery
retainer.
HIGH CAPACITY
BATTERY LCP500-24B
- OR -
STANDARD CAPACITY
BATTERY LCP500-4B
(IN ADAPTER)
Remove the body of the Controller from its wall mount or or remove the desk mount from the back of the Controller.
or or
7. Connect the battery to the battery receptacle inside the battery compartment.
8. Reattach the rear cover to the Gateway and secure it in place with the screw.
9. Plug the power cord (and Ethernet cable, if used) back into the receptacle(s).
10. Return the Controller to its mounting location (on the wall, or reattach the desk
stand).
11. On the MyHome Gateway App
screen. The system confirms "Battery successfully installed".
12. Press OK OK. The system returns to the Advanced
OK OK
13. Press
Sensors
Clear sensor low-battery warnings by entering a user code on the Controller. Follow the
sensor's battery replacement instructions.
NOTES NOTES: For SiX™ series sensors and wireless keys, remove the battery and wait about 10 NOTES NOTES
seconds before installing the replacement battery.
BATTERY
RETAINER
MyHome Gateway App screen, press OK MyHome Gateway App MyHome Gateway App
to return to the previous screen(s).
SCREW
gw-BattRepl-2-0xx-V0
OK on the battery installation procedure OK OK
Advanced menu.
Advanced Advanced
51