Configuring Thermostat Periods; Configuring Cameras; Adding/Deleting Devices - Honeywell W7006A User Manual

Home Controller Gateway User Guide
To change the number of rings:
To add a new camera:
To remove a camera:
To add a new device:
To delete a device:
69-1321-1
If you do not have an answering machine or answering service, set the number-of-
rings-before-pick-up to a number that is greater than the number of rings it usually takes
you to answer the phone. For example, if you normally pick up the phone on the
second ring, the Home & Away System should be set to pick up after three or more
rings.
On the System Configuration page, select Telephone in the Show settings for list, then
select a value from the Number of rings pull-down list.
Your programmable thermostat uses Periods (Wake, Leave, Return, Sleep) to
automatically change thermostat settings. These periods will be configured during
installation. You can view and modify them at any time using either your thermostat or
the Web interface.
To modify the period settings using the Web interface, navigate to the Schedule page
and follow on-screen instructions to make changes.
The Camera Configuration page allows you to add and remove Web video cameras to
obtain video snapshots remotely. The cameras must be compatible with your Home &
Away System. To configure the camera, first install the camera according to the
instructions. You should be able to view the camera from a Web browser.
Enter the IP address of the camera in one of the camera Web address fields. The
Address should contain four numbers separated by periods (127.0.0.1) and click the
button next to the camera address. This writes the camera address into the Home &
Away System .
Enter the Web address 0.0.0.0 and select the button at the end of the field.
To modify the period settings using the Web interface, navigate to the Schedule page
and follow on-screen instructions to make changes.
The Add/Delete Devices page allows you to add or delete lights from your system.
Note that when you delete a light, it will be removed from the associated schedules
and Lifestyles.
Select the House code and Unit code address for the X10 device. Set the address
wheels on the device to the same address. Select either light or appliance as the
device type and enter a device name. The name should be less than 32 characters.
Select Apply. The device is now available.
Select the device name from the list and press the Delete button.
22
Product Release Version 3.x.x

Configuring Thermostat Periods

Configuring Cameras

Adding/Deleting Devices