Commands; Setting The Time Of The Day (Td); Basic Programming; Day Of Override (Do) - Pentair FLECK 9100 SXT Installer Manual

3. Parameter display
4. Data display
5. PM indicator
6. Flow indicator
7. x1000 indicator
8. Programming icon
6.2.

Commands

A Press to pass to the next step.
B Use and
6.3.

Setting the time of the day (TD)

Set the time in the system.
A Press and hold
the service icon and the parameter display reads TD.
B Set the time with
C Press to validate the selection and return to the service mode, or wait for 10 seconds.
6.4.

Basic programming

6.4.1. Day of Override (DO)

Determine the maximum number of days of operation without regeneration.
A Press and
sequence.
B Select the number of days of Override with
C Press to validate the selection and advance to the next parameter.
Ref. MKT-IM-004 / A - 27.10.2016
→ RS: Reserve selection;
→ RT: Regeneration time;
→ SF: Safety factor;
→ SV: Software version;
→ TD: Time of day;
→ TS: Unit in service;
→ VT: Regeneration mode;
→ VU: Volume used.
Regeneration cycles:
→ B1: First backwash (for dF2b regeneration mode);
→ B2: Second backwash (for dF2b regeneration mode);
→ BD: Brine draw;
→ BF: Brine fill;
→ BW: Backwash;
→ RR: Rapid rinse.
→ Appears if controller set in US unit.
→ Flashes when outlet flow is detected.
→ Appears when the displayed number is bigger than 9999.
→ Appears in programming modes.
to adjust the values.
or until the programming icon replaces
or .
simultaneously for 5 seconds to enter the menus
Installer Manual Fleck 9100 - SXT - Programming
and .
43 / 94