Programming; Display; During Service; Commands - Pentair FLECK 2910 NXT Installer Manual

6.

Programming

6.1.

Display

6.1.1. During service

1. System type
2. Valve address
3. Valve status
4. Flow indicator
5. Time of the day
6. Operating mode
6.2.

Commands

A
Note
At any time, press D to return to the home screen without saving.
A
Note
Menus are displayed in a defined and incremental order.
A Press to pass to the next step.
B Use to move the cursor to the next digit.
C Use and
D Press D at any time to exit programming mode without saving.
Ref. MKT-IM-002 / A - 18.11.2016
1 2
7#1 SRV* 08:26HR
6
→ #4: single valve;
→ #5: lockout system, 2 to 4 valves;
→ #6: parallel system, sequential regenerations, 2 to 4 valves;
→ #7: duplex alternating system, 2 valves;
→ #9: alternating system, 2 to 4 valves;
→ #14: demand system, 2 to 4 valves.
→ #-: single valve;
→ #1: address 1, lead valve;
→ #2: address 2;
→ #3: address 3;
→ #4: address 4.
→ CHG (change of state): lower drive changes position on double piston
valve;
→ INI (initializing): after a power failure or a change in the programming,
the controllers initializes for approximately 30 seconds;
→ RGQ (regeneration queued): in a meter delayed system, the reserve
capacity has been entered or a manual regeneration has been registered;
→ LCK (lock): the controllers has acquired the lockout signal;
→ SRV (service): valve in service;
→ SBY (standby): valve in standby.
→ Rotates when flow is going through the meter.
→ Remaining volume in volumetric mode;
→ Remaining days before a regeneration in timeclock mode.
to adjust the values.
Installer Manual Fleck 2910 - NXT - Programming
3 4 5
51 / 98