Programming; Display - Pentair FLECK 9100 SXT Installer Manual

Installer Manual Fleck 9100 - SXT - Programming
6.

Programming

Note
As soon as programming mode is entered, all parameters can be displayed or set to suit the
needs. Depending on the current programming, some functions will not be displayed or will
not be changeable.
Note
If none of the buttons are pushed for 5 minutes in the Programming mode (basic or master
mode), or if there is a power failure, the controller returns to Service mode and any changes
made are not stored.
Note
Menus are displayed in a defined and incremental order.
A
Mandatory
In order to store the new settings in the programming mode, it is necessary to go through
all the parameters.
6.1.

Display

1. Service icon
2. Error /
Information icon
3. Parameter display
42 / 94
→ Appears in service mode;
→ Flashes if a regeneration cycle has been queued.
→ Appears in case of error, see page 74, or in diagnostic mode, see
page 50.
Master programming and diagnostic modes:
→ C: Unit capacity;
→ CD: Current day;
→ CT: Regeneration control type;
→ DF: Display format;
→ Dn, n=1 to 7: Day of week;
→ DO: Days override;
→ FM: Flow meter;
→ FR: Current flow rate;
→ H: Feedwater hardness;
→ HR: Hours in service;
→ K: Meter pulse;
→ NT: Number of tanks;
→ PF: Peak flow rate;
→ RC: Reserve capacity;
Ref. MKT-IM-004 / A - 27.10.2016