Pentair FLECK 9100 SXT Installer Manual page 64

Installer Manual Fleck 9100 - SXT - Maintenance
9.2.4.3 Replacing the lower piston and/or its front side seal and spacer kit
Caution
Use only approved silicon grease or soapy water.
No.
A Remove the gearing system, see "Replacing the micro-switches", page 75.
B Using pliers, remove the piston (4).
C Remove the screw (1) and the piston plate (2).
D Remove the cover cup (3) from the piston (4).
E Using a small hook, remove a seal (5).
F Using the puller, remove a spacer (6).
G Repeat E and F for all the seals and spacers.
H Lubricate all seals (5) with approved lubricant only.
I Put back a new seal (5) using the stuffer.
J Put back a spacer (6) using the stuffer.
K Repeat I and J for all the seals and spacers.
L Lubricate the piston (4) with approved lubricant only.
M Put back the piston (4).
N Put back the cover cup (3).
O Put back the piston plate (2) and the screw (1).
P Rebuild the gearing system, see "Replacing the micro-switches", page 75.
64 / 94
Operation
Ref. MKT-IM-004 / A - 27.10.2016