6.5.13.3 For regeneration type Other
Note
The regeneration cycles are identified as R1 to R6.
AB Press
or
AC Press
to validate the selection and move to the next regeneration
cycle.
AD Repeat AB and AC for each cycle.
6.5.14. Flow meter type (FM)
Select the flow meter type.
Options:
•
P0.7: ¾" paddle wheel meter (Standard setting for 9100 SXT);
•
t0.7: ¾" turbine meter;
•
P1.0: 1" paddle wheel meter;
•
t1.0: 1" turbine meter;
•
P1.5: 1½" paddle wheel meter;
•
t1.5: 1½" turbine meter;
•
P2.0: 2" paddle wheel meter;
•
Gen: Generic or other non-Fleck meter.
AE Press
or
AF Press
to validate the selection and move to the next parameter or
exit master programming mode and save modifications done.
6.5.15. Meter pulse
Set the meter pulse for a non-standard flow meter.
Note
The meter pulse parameter is only available if the Gen option has been set in flow meter type
selection.
AG Press
or
AH Press
to validate the selection and to exit the master programming
mode.
Ref. MKT-IM-004 / A - 27.10.2016
to set the regeneration time of this cycle.
to select the flow meter type.
to set the meter constant in pulses per unit of volume.
Installer Manual Fleck 9100 - SXT - Programming
49 / 94