Pogo Pin Connector Cable - HP Spectre x2 Maintenance And Service Manual

POGO pin connector cable

Description
Display panel cable (includes double-sided adhesive)
Before removing the POGO pin connector cable, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
5. Remove the bottom bezel (see
6. Remove the battery (see
Remove the POGO pin connector cable:
1. Disconnect the POGO pin connector cable (1) from the system board.
2. Detach the POGO pin connector cable (2) from the back cover. (The POGO pin connector cable is attached
to the back cover with double-sided adhesive in two locations.)
3. Remove the Phillips PM1.5×2.2 screw (3) that secures the POGO pin connector to the back cover.
4. Remove the POGO pin connector cable (4).
5. Remove the POGO pin connector cable.
Reverse this procedure to install the POGO pin connector cable.
30 Chapter 5 Removal and replacement procedures
Display panel assembly on page
Bottom bezel on page
Battery on page 25).
20).
24).
Spare part number
924173-001