Power Connector Cable - HP ENVY x360 Series Maintenance And Service Manual

Power connector cable

Table 5-11 Power connector cable description and spare part number information
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the power button board (see
Remove the power connector cable:
1. Remove the four Phillips M2.5×6.6 screws (1) that secure the display left hinge to the keyboard/top cover.
2. Swing the display left hinge (2) up and back as far as it will go.
3. Disconnect the power connector cable (1) from the system board.
4. Release the power connector cable from the retention clips (2) and routing channel built into the keyboard/
top cover.
Bottom cover on page
Battery on page 30).
Power button board on page
28).
48).
Component replacement procedures
Spare part number
L53538-001
49