Power Button Board - HP Spectre x2 Maintenance And Service Manual

1. Release the ZIF connector (1) to which the power button board cable is connected, and then disconnect
the power button board cable from the system board.
2. Disconnect the right speaker cable (2) from the system board.
3. Remove the right speaker (3).
Reverse this procedure to install the right speaker.

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the tablet.
3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the tablet.
4. Remove the display panel assembly (see
the following components:
a. Bottom bezel (see
b. Battery (see
c. Right bezel (see
d. The right speaker (see
Display panel assembly on page
Bottom bezel on page
Battery on page 25)
Kickstand on page 32)
Right speaker on page
24)
36)
Component replacement procedures
Spare part number
924169-001
20), and then remove
37