Activating/Deactivating The Handset - Siemens HiPath 4000 Operating Manual

Conducting calls – the basic functions
Step by Step
Please enter
PIN:
2

Activating/deactivating the handset

a
Press the On-hook key until the activation or deactiva-
tion is confirmed by a crescendo tone sequence.
PIN
If the default PIN has not been changed (0000), the
handset is ready for operation as soon as it is switched
on. If a PIN was set, it must be entered before the hand-
set can be operated.
o
Enter the PIN.
[
Confirm your entry. The handset is ready to use.
Displaying the connection quality
The strength of the incoming signal is displayed by the
"receive field strength" icon in on or message status:
|
Flashing, no reception
Ò
Low receive field strength
Ñ
50% receive field strength
i
75% receive field strength
Ð
100% receive field strength
The radio range is different indoors and outdoors
( Page 108). Please consult your system administra-
tor in the event of range problems.
Charging the battery pack
You may only use the charging shell provided for the
handset.
The handset charges when sitting in the charging shell,
even when deactivated. If the handset is active, the
charging status display flashes on the display.
If the handset deactivates because the battery pack is
flat, it automatically reactivates and is ready for opera-
tion as soon as you place it in the charging shell. The
charging operation starts. If a PIN was set, it must be
entered first to allow charging to start.