Charging And Using The Battery Pack; Battery Pack Operating Times And Charging Times - Siemens HiPath 4000 Operating Manual

Putting the handset into service

Charging and using the battery pack

To charge the battery pack, insert the handset into the charging shell with
the keypad facing forwards.
The charging status is indicated by the charge status display. This flashes
during charging:
=
e
V
U

Battery pack operating times and charging times

The operating times are only achieved after several charging and discharg-
ing cycles.
Capacity
(mAh)
700
(original battery pack)
You can significantly prolong the handset's standby time by deactivating
the backlight.
16
Attention:
Only use the relevant approved power supply units for operating
the charging shell (for order numbers see
Battery pack is flat
Battery pack is 33% charged
Battery pack is 66% charged
Battery pack is 100% charged
Note:
• Initial charging: Charge the battery pack for at least 10 hours
without a break, regardless of the charging status icon. With-
out replacing it in the charging shell, use the handset until the
"battery low" beep is heard. This action aligns the charge status
display with the operating times of the battery pack.
• To attain full operating and charging times (
out replacing it in the charging shell, use the handset until the
"battery low" beep is heard.
• For future charging: you can replace your handset in the charg-
ing shell each time it has been used. Charging is electronically
controlled which ensures that the battery pack is charged opti-
mally.
Stand-by mode
(hours)
approx. 250 (10 days)
Page 108).
Page 16): With-
Talk time Charging time
(hours) (hours)
approx. 10 approx. 3.5