Wd4190; Positioning The Appliance - Smeg WD2145 User Manual

Instrument washers
Hide thumbs Also See for WD2145:
Table of Contents

Advertisement

10.2.3 WD4190

N.B.: on the WD4190 series, the optional peristaltic pump P3 does not cause an increase in depth
VERSION
STANDARD
STANDARD + ACQUASTOP
STANDARD + PAD1
STANDARD + P3

10.3 POSITIONING THE APPLIANCE

IMPORTANT
The appliance must be positioned with its back near a wall (with a gap of at least 10 mm) and must be installed by an
authorised engineer.
The installer engineer is responsible for the correct operation of the appliance after installation and must also
provide the user with all information required for its correct use.
During installation, the protective film must be removed from the steel outer surfaces.
The set of installation accessories (seals and hose ties) is inside the chamber.
The appliance can be installed with its sides flush against those of the adjacent cabinets, taking care not to obstruct
the steam vent on the rear. The wall at the back should be in masonry or another waterproof material.
Also take care that the heat does not reach any electrical circuits or sockets behind the appliance.
The appliance has water intake and drain hoses which can be positioned leading to the right or left, depending on
installation requirements.
If ordered in the appropriate version, the appliance can be installed built under a worktop; installation must be carried
out by skilled staff.
LEVELLING
After positioning the appliance, screw the feet down or unscrew them to adjust its height and level with the aid of a
spirit level so that it will be perfectly horizontal (max angle tolerance allowed: 0.5 °, corresponding to a maximum
permissible difference in height between opposite corners of the appliance of about 5 mm).
Correct levelling will ensure that the appliance operates correctly.
WARNING
Any adjustments, maintenance, etc. must be performed with the device switched off and disconnected from power
sources.
User Manual
fig. 40 – WD4190 - Simplified drawing, product overall dimension diagram
A
600
600
710 / 750
600
WD2145-WD1160-WD4060-WD4190
B
C
600
30
600
30
600
30
600
30
D
E
900
850
900
857
900
850
900
850
Page 73 - 85
F
> 10
> 10
>10
> 10

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd1160Wd4060Wd4190

Table of Contents