Programs Installed; Resins - Softener, Regeneration And Washing Phase - Smeg WD2145 User Manual

5.6

PROGRAMS INSTALLED

Please refer to the documents supplied with the device:
"WD2145 program table" and "WD1160-WD4060-WD4190 Program Table".
N.B: The drying phase is only present in the WD4060, WD4190 series.
CUSTOM PROGRAMS
In addition to the Standard Original programs, which cannot be modified by the user, modifiable
programs are also available.
The Custom programs are programs which can be modified to meet specific requirements.
Programs can only be modified using the TRACELOG software; contact your local dealer for
information concerning the use and installation of the program.
MAINS WATER - DEMINERALISED WATER in PROGRAMS
The enclosed table indicates when a specific phase takes in cold water and when demineralised
water.
If demineralised water is deselected by means of the appliance setup parameters, the appliance
will always take in cold water.
Whenever possible, connection to demineralised water is recommended, for better final rinsing
results and to avoid the formation of limescale.
5.6.1

RESINS - SOFTENER, REGENERATION AND WASHING PHASE

The softener incorporated in the device removes calcium compounds from the intake water to reduce its hardness.
The softener comprises a container of ion exchanger resins, which must be regenerated regularly.
The appliance decides when a resin regeneration and washing cycle is needed depending on the hardness set and the
quantity of water treated.
Resins washing cycles are performed at the start of a washing cycle, to avoid the risk that standing brine (salt and
water) might cause corrosion.
User Manual WD2145-WD1160-WD4060-WD4190 Page 26 - 85