Key To The Symbols Used In The Manual And On The Appliance - Smeg WD2145 User Manual

3 KEY TO THE SYMBOLS USED IN THE MANUAL AND ON THE APPLIANCE

The following is the key to the symbols used on the appliance and in this manual, as required by point 5.4.4.e of
IEC61010-2-040:2005.
Read with particular attention.
(Symbol which appears beside particularly important instructions or warnings).
ON" Power
(Symbol 5007 IEC 60417-1). Only for WD4190: on the main switch, to indicate connection to the
mains.
"OFF" Power
(Symbol 5008 IEC 60417-1). Only for WD4190: on the main switch, to indicate disconnection from
the mains.
Warning, danger: refer to the manual.
(The symbol appears on the appliance's technical dataplate to emphasise that staff must read the
manual before using the device.
The symbol appears in the manual next to safety instructions)
Warning, hot surface.
(the symbol is affixed to the appliance close to parts which may heat to high temperatures and
constitute a burn hazard - do not touch parts near this symbol. The symbol appears in the manual
to emphasise safety instructions relating to the burn hazard).
Warning, electric shock hazard.
(The symbol is affixed close to live parts - the device's power supply must be disconnected before
doing any work on these parts. Never touch live parts unless the electricity supply is disconnected).
Transport, storage and unpacking precautions.
Biohazard.
Flammability hazard.
At the end of its working life, the product must be consigned to a disposal plant for recovery and
recycling in accordance with the relevant legislation in the country of installation. Contact the
specialist disposal consortia. At the end of its lifetime the appliance may be contaminated,
especially the chamber and water circuit (e.g. if the appliance has ended its working life due to a
fault that has caused the failure of the last thermal disinfection cycle): take appropriate care when
decommissioning. THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE
2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS
PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE
CONSEQUENCES FOR THE ENVIRONMENT AND HUMAN HEALTH, WHICH COULD OTHERWISE BE
CAUSED BY INAPPROPRIATE WASTE HANDLING OF THIS PRODUCT..
CE marking, notified body IMQ (CE0051 only on "WD" series models, medical devices).
This symbol appears on the appliance's technical data label and in this manual, indicating that it is
a medical device which holds EC CERTIFICATION issued by IMQ ("0015" is the code number of the
notified body IMQ).
User Manual WD2145-WD1160-WD4060-WD4190 Page 12 - 85