Alarms And Warning Messages - Smeg WD2145 User Manual

8 ALARMS and WARNING MESSAGES

This section provides instructions for interpreting alarm messages and taking any appropriate measures. Information
supplied in compliance with point 5.4.4.j of IEC61010-2-040:2005.
The appliance's display has backlit LED symbols.
See also the explanations provided in the INDICATOR LEDS - DETAILED EXPLANATIOn section.
The symbols in the top of the display contain WARNINGS which the appliance provides to its users, as detailed below
(For full information, also see the "DESCRIPTION OF CONTROLS AND PROGRAMS" section).
SYMBOL
No detergent
Lights up if the detergent level sensors are installed and one of them is at "minimum" level.
The error is displayed at the end of the cycle and in combination with the LED the segment
display shows the code of the detergent to which the warning refers:
P1: code on display "A-:68"
P2: code "A-:69"
P3: code "A-:70"
Activated at the end of the cycle and when the user attempts to start a new program.
The washing cycle can be started with this message present (i.e. overriding the warning) by
pressing the Start/Stop button again.
If two or more similar alarms (e.g. cans P1 and P2 empty), the Start/Stop button will have to be
pressed twice or more before the cycle can be started. (The device's internal memory records
the event but allows execution of the cycle).
Maintenance: filter replacement (only for WD4060, WD4190 series)
Active if the dryer is present and the absolute filter is installed. (The absolute filter is optional
on the "GW" series).
The LED indicates that the absolute filter needs to be replaced.
Illumination of the symbol is triggered by the number of drying system operating hours, set at
500h when the filter is new. The filter must be replaced by authorised staff.
Keeping the filter in operation after the end of its useful life will lead to poor drying results. If
the filter is fulled, the drying air flow rate is reduced.
The filter's useful life may be less than the 500 h set, depending on the amount of dirt in the
environment. If drying performance deteriorates, users should have the filter changed earlier.
The appliance does not signal this type of wear, but only wear arising from the hours actually
worked.
User Manual
fig. 40 – Central display, detail of backlit symbols.
WD2145-WD1160-WD4060-WD4190
MEANING
Page 56 - 85