General Warnings - Smeg WD2145 User Manual

Instrument washers
Hide thumbs Also See for WD2145:
Table of Contents

Advertisement

4 GENERAL WARNINGS

Leaning or sitting on the open door of the device might cause it to tip over, putting people in
danger. The door is not designed primarily to support loads.
The maximum weight which can be loaded on the door, including the weight of the instrument
trolley, must never exceed
- if the weight of the instrument trolley and baskets is excluded, the maximum load must never
exceed:
Only WD4060, WD4190 series: For optimal DRYING, the load for processing must never exceed
15 kg.
With use of the glassware washer, localised or general discolouring of the heating element may
occur. This is normal since it is due to the operating mode and does not reduce the appliance's
effectiveness.
In the event of malfunction, disconnect the appliance from the electricity supply and turn off the
water tap. Then contact your nearest authorised Service Centre.
Open the door carefully, first waiting for the wash cycle to end.
The appliance has an automatic door opening system; do not force the door open while a program
is in progress.
The appliance must only be used by staff suitably trained in its operation.
The chamber of the appliance is not designed for users to climb into it. The user must never climb
into the chamber; this might put his safety at risk (ref. 7.102 IEC61010-2-040:2005).
DEMI WATER ABSENCE
If demineralised water is not available, the user is responsible for ensuring that the quality of the
water supplied to the medical device does not cause mineral salts or other substances to be
deposited on the treated instruments, rendering their subsequent use unsafe.
Do not place flammable substances inside the device. Do not use flammable detergents.
Never place alcohol or solvents such as turpentine, which might cause an explosion, inside the
appliance. Do not place materials dirty with ash, wax or paint inside the appliance.
When moving the appliance around, a forklift truck or pallet truck must be used.
Before leaving the factory, the base of the appliance is secured to a pallet, which is used for lifting
and transporting it.
Do not use appliances which have been damaged in transit!
If in doubt, contact your dealer.
STORAGE: The device should be stored in a closed place, under conditions of temperature,
humidity similar to those described for its operation, see section "INSTALLATION".
Once decommissioned, the appliance must be rendered unusable. Cut the power supply cable
after removing the plug / disconnecting the cable from the power socket.
User Manual
WD1160, WD4060, WD4190: 37kg
WD2145: 18kg
WD1160, WD4060, WD4190: 23kg.
WD2145: 15Kg
WD2145-WD1160-WD4060-WD4190
Page 13 - 85

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wd1160Wd4060Wd4190

Table of Contents