Registering Devices; Deregistering Devices; Setting Device Profiles (Device Names, Locations, And Other Settings) - Panasonic KX-HNB600 User Manual

Using the app
*1 8 mobile devices can be registered to the hub, however, only the first 4 can use phone features.

Registering devices

If you purchased any devices separately from the hub, you must register them to the hub before you can
use them.
Note:
R To register a mobile device, use the procedure described in "Registering other mobile devices to the
hub", Page 28.
1
From the [Home Network] app home screen, tap [Settings].
2
Tap [Device Registration].
3
Tap [Registration].
4
Select the type of device that you want to register.
5
When registering a handset
When prompted, place the handset on its charger.
When registering a camera, sensor, or other device
When prompted, press and hold the registration button on the device that you want to register until
the device's LED indicator blinks in green.
R When registration is complete, the hub sounds one long beep.
R If registration fails, the hub sounds several short beeps.
Note:
R If you register a large number of devices to the hub, you may forget which name is assigned to each
device. In this case, see "I cannot remember the names I assigned to my devices", Page 114.
R You can customize the name of each device and assign them to locations for easier management. For
details, see "Setting device profiles (device names, locations, and other settings)", Page 92.

Deregistering devices

1
From the [Home Network] app home screen, tap [Settings].
2
Tap [Device Registration].
3
Tap [Deregistration].
4
Select the type of device that you want to deregister.
5
Tap the name of the device that you want to deregister, and then tap [OK].
Setting device profiles (device names, locations, and other
settings)
Device profiles allow you to assign a name and location to each device. These settings are especially
convenient when you have several devices of the same type. Additional settings are available depending
on the type of device.
Note:
R When changing a device name, any characters not supported by the hub will be replaced by "*".
92