Panasonic KX-HNB600 User Manual page 43

Keychain remote LED indicator
Off
Green
Green and red
Orange
Red
*1 The LED lights for about 2 seconds after a button is pressed, then turns off. If the LED indicator does
not light when you press a button, the battery must be replaced.
*2 The LED indicator does not indicate the remote's status if the sensor has not been registered.
Backup battery LED indicator
Off
Green
Orange
Red
*1 You can configure the backup battery so that its LED indicator does not light in this state. See
"Setting device profiles (device names, locations, and other settings)", Page 92.
Smart plug LED indicator
Off
Green
Red
*1 You can configure the smart plug so that its LED indicator does not light in most states. See "Setting
device profiles (device names, locations, and other settings)", Page 92.
*2 In this case, the smart plug will turn off automatically. To turn the smart plug on again, disconnect it
from the power outlet, disconnect the connected electric device, and then connect it again.
Normal operation, or no battery power
[Disarm] mode selected (you pressed the disarm button), or you pressed
*2
the smart button
Registration mode (you pressed and held
Low battery
Signal is being sent to the hub (you are pressing a button)
[Arm: Away] mode selected (you pressed the arm button)
Keychain remote is out of range of the hub, or is not registered to a hub
Battery is fully charged
Battery power is being consumed
Registration mode (you pressed and held
*1
Battery is charging
Backup battery is out of range of the hub, or is not registered to a hub
No battery power, or device error
No power, smart plug is off, or LED indicator is turned off
Smart plug is on
Registration mode
Smart plug is out of range of the hub, or is not registered to a hub
Connected electric device is drawing too much current or wattage
Using the app
*1
)
*2
)
*1
*2
43