Setting The Hub's Wi-Fi Settings Again - Panasonic KX-HNB600 User Manual

Note:
R You cannot delete the wireless access point that your mobile device is currently connected to.
[Port Forwarding] settings
These settings are only required if you need to configure your wireless router's port forwarding feature in
order to access the hub while away from home.
Important:
R In order to use this feature, you must first configure the hub to use a static IP address ( "Changing IP
settings", Page 100).
1
From the [Home Network] app home screen, tap [Settings].
2
Tap [Wi-Fi Settings].
3
Tap [Port Forwarding].
4
Turn on the [Enable] radio button.
5
Tap the field next to [Port A] and then enter the desired port number.
Repeat this step for [Port B] and [Port C].
R A value must be assigned to each port.
R Only port numbers 62000–63000 can be assigned.
R Configure your wireless router's port forwarding feature to forward these ports to the static IP
address that you have assigned to the hub.
6
When finished, tap [OK].
[MTU Settings] (maximum data size setting)
This setting affects how data is sent over the network. Typically this setting does not need to be changed.
1
From the [Home Network] app home screen, tap [Settings].
2
Tap [Wi-Fi Settings].
3
Tap [MTU Settings].
4
Select the desired value and then tap [OK].

Setting the hub's Wi-Fi settings again

If your wireless router's SSID (i.e., network name) or password changes, or if you replace your wireless
router with a new one that uses a different SSID or password, you will need to set the hub's Wi-Fi
settings again.
If a cordless handset is registered to the hub, you can use the cordless handset to set the hub's Wi-Fi
settings. Refer to the Wi-Fi settings information in the operating instructions included with your cordless
handset.
1
Press and hold the 3 registration buttons on the side of the hub and the Wi-Fi SETUP button on the
back of the hub at the same time (4 buttons total) until the hub's LED indicator blinks in green and
yellow.
2
Wait for the hub's LED indicator to light in yellow.
3
From the [Home Network] app home screen, open the options menu (see "Displaying the options
menu", Page 35).
4
Tap [Deregistration from Hub] ® [OK].
5
Follow the initial setup procedure (see "Initial setup", Page 25).
Using the app
101