Panasonic KX-HNB600 User Manual page 115

→Arm the alarm system ( "Arming and disarming the alarm system", Page 45).
R The sensor is not enabled for the current arm mode.
→Change the settings for the current arm mode ( "Alarm system settings", Page 46).
R The desired feature is not enabled.
→Temperature alert (indoor cameras only) and sound alert (indoor camera only) do not function as
part of the alarm system. Make sure the desired feature is enabled ( "Temperature alert (indoor
cameras only)", Page 62, "Sound alert (indoor cameras only)", Page 62)
R The hub's date and time setting is incorrect.
→Adjust the date and time setting ( "[Time Adjustment] setting", Page 98).
The glass break sensor makes false detections; battery life seems too short
R False detections may occur and battery life may be drastically reduced if devices that produce
continuous sound (TVs, music players or speakers, musical instruments, etc.) are located near the
sensor.
→Move any such devices further away from the sensor, or re-locate the sensor.
Refer to the following after checking the general troubleshooting information described in "General
information", Page 105.
[Device is in use.] is displayed
R Another user (i.e., mobile device) is already accessing the hub, the same screen, or the same feature.
→Wait for the other user to finish and then try again.
[Failed] is displayed
R The smart plug is out of range of the hub.
→Move the smart plug closer to the hub and try again.
R An error occurred while accessing the smart plug.
→Check all connections and try again.
[System is busy. Please try again later.]
R Another event, such as a sensor detection or a landline call being received, interrupted the current
operation.
→Wait and try again later.
I cannot remember the names I assigned to my smart plugs
R See "I cannot remember the names I assigned to my devices", Page 114.
Energy consumption is displayed as "0.00 kWh" even though I am using the connected electric
device
R If an electric device that consumes very little power is connected, such as a low-power LED lamp,
energy consumption may be displayed as "0.00 kWh".
Refer to the following after checking the general troubleshooting information described in "General
information", Page 105.
[Device is in use.] is displayed
R Another user (i.e., mobile device) is already accessing the hub, the same screen, or the same feature.
→Wait for the other user to finish and then try again.
[This function isn't available.] is displayed
R You tried to operate a feature that is not available while talking on a landline call.
→Try again after you disconnect the landline call.
[Restricted number] is displayed
R A cordless handset was used to restrict your mobile device from making this call.
Troubleshooting
115