Flush Cooling System And Changing Coolant (Ad); Flush Cooling System And Changing Coolant (Ad) - Kioti CK2810 Manual

fLUSH CooLing SySTeM AnD CHAnging CooLAnT (AD)

(1) Drain cock
1. stop the engine and let it cool.
2. to drain coolant, remove the drain
plug from the radiator and turn
the radiator cap to the 1
release pressure in the radiator.
then, remove the cap completely.
3. after all coolant is drained, close
the drain cock.
4. fill with clean water and anti-
freeze.
5. install the radiator cap securely.
M56(TB110)(CK2810)-호주판-OM-07.ind29 29
M56O727A
(1) reservoir tank
(a) full
6. add coolant to the reservoir tank
to the "full" level.
7. start and operate the engine for
st
notch to few minutes.
8. stop engine and let cool.
9. check coolant level of reservoir
tank and radiator. add coolant if
necessary.
Coolant capacity
7.8 l (2.06 u.s.gal)
To avoid accidents:
•
Do not remove the radiator
cap while the coolant is hot.
yo u c a n b e b u r n e d b y h o t
steam. Make sure to remove
it after the coolant is cooled
down enough.
•
Even though the coolant is
M56O728A cooled down, turn the cap to
its first stop and then wait un-
(2) radiator cap
til it is depressurized before
(B) low
removing the cap completely.
7
- 2
maintenance
CAUTION
5 7
2012-10-16 오후 2:47:33