Kioti CK2810 Manual page 113

7. install the top link to the top link
hole of the implement. Loosen the
lock nuts of top link and turn the
top link handle to adjust the length
of it as needed. Align the pin holes
for top link and top link hole on the
implement to insert the set pin.
insert the snap pin into the set pin
hole securely to hold the set pin.
m56(tB110)(Ck2810)-호주판-om-06.ind3 3
H61O616A-2
8. raise up the implement by posi-
tion control of tractor. remove the
implement support as needed.
Align the implement by adjusting
the length of the check chains on
both sides. tighten the lock nuts
on the check chain securely.
9. Adjust the tip angle of implement
by adjusting the length of top link.
tighten the top link lock nuts se-
curely.
3-point HitcH impLement And LoAder operAtion
•
when selecting a universal
joint, make sure to consult your
local dealer.
•
when deciding the length of the
universal joint, make sure that
it is not too short to fall out with
an implement at the highest po-
sition and that it is not too long
to interfere with other parts with
H61O608A
an implement at the lowest po-
sition.
•
slide the joint front and back to
make sure that the lock pin of
the universal joint is seated into
the groove of the PTO shaft.
10. Adjust the balance of implement
by adjusting the length of lift rod
(rH). tighten the turn buckle
lock nut of lift rod (rH) securely
afterward.
6
5 5 - 
 
- -
IMPORTANT
6 5
2012-10-16 오후 2:36:48