Configuring Et 200Mp Distributed I/O System - Siemens SIMATIC S7-1500 System Manual

6.2

Configuring ET 200MP distributed I/O system

Introduction
You configure and assign parameters to the ET 200MP (interface module and I/O modules)
with STEP 7 or in the configuration software of another manufacturer.
Requirements
Table 6- 3 Requirements for installation
Configuration software
STEP 7 (TIA Portal) as of V13
STEP 7 V5.5 SP3 or higher
Software of another manufacturer
The TIA Portal supports GSDML specification V2.25. The ET 200MP is supplied with a GSD file based on specification
1)
V2.3. The GSD file can be installed and used in the TIA Portal.
Configuring operation on PROFIBUS DP using a GSD file
If you want to configure the operation on the PROFIBUS DP using GSD file, note the
following additional requirements:
Table 6- 4 Requirements for PROFIBUS DP with GSD file
I/O modules
Input/output modules 35 mm
Input/output modules 25 mm
Technology modules (TM)
Communications module CM PtP
Configuration of the ET 200MP
Read the STEP 7 online help and/or the documentation of the configuration software
manufacturer.
Automation system
System Manual, 12/2014, A5E03461182-AC
Requirements
IM 155-5 PN ST and IM 155-5 DP ST: as of
1)
firmware version V2.0.0
IM 155-5 PN HF: as of firmware version V1.0.0
PROFINET IO GSD file: GSDML-Vx.y-siemens-
et200mp-"Date in format yyyymmdd".xml
(http://support.automation.siemens.com/WW/view/en/1
9698639/130000)
PROFIBUS DP GSD file: SI0xxxxx.gsx
(http://support.automation.siemens.com/WW/view/en/1
0805317/133300)
Required firmware version
IM 155-5 DP ST as of ...
V1.0.0
V2.0.0
V2.0.0
V1.0.0
6.2 Configuring ET 200MP distributed I/O system
Installation information
STEP 7 online help
STEP 7 online help
Manufacturer documentation
Required firmware version I/O modules
as of ...
V2.0
V1.0
V1.1
V1.0.1
Configuring
105