Hardware Configuration Of The Et 200Mp Distributed I/O System With Profibus Interface Module - Siemens SIMATIC S7-1500 System Manual

Application planning
3.2 System and load power supply
3.1.3 Hardware configuration of the ET 200MP distributed I/O system with
PROFIBUS interface module
Maximum configuration
The integrated system power supply of the interface module feeds 14 W into the backplane
bus. The exact number of the I/O modules operated with the interface module depends on
the power budget (see section Power balance calculation (Page 34)).
Figure 3-3
Applicable modules
The following table shows which modules may be used in the various slots:
Table 3- 3
Module type
Interface module
Analog and digital I/O modules
Communications modules
•
Technology modules
26
Maximum configuration ET 200MP with IM 155-5 DP
Assignment of slot numbers
Point-to-point
Permissible slots Maximum number of modules
2 1
3 - 14 12
3 - 14 12
3 - 14 12
System Manual, 12/2014, A5E03461182-AC
Automation system