5.9
Marking the I/O modules
5.9.1
Labeling strips
Introduction
Mark the pin assignment of the I/O modules using labeling strips. You can label the labeling
strips as desired and slide them into the outside of the front cover.
The labeling strips are available in the following models:
● Pre-prepared strips that are included with the I/O module as delivered.
● DIN A4 sheets, pre-perforated strips for machine printing, see chapter Accessories/Spare
parts (Page 224)
Preparing and installing the labeling strip
Proceed as follows to prepare and install the labeling strips:
1. Label the labeling strip.
2. With a pre-perforated strip: Separate the labeling strip from the sheet.
3. Slide the labeling strip into the outside of the front cover.
①
Figure 5-19
Automation system
System Manual, 12/2014, A5E03461182-AC
Labeling strips
Marking with labeling strips
Wiring
5.9 Marking the I/O modules
77