Keiser M7i Installation And Operation Manual page 10

M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
BLUETOOTH
®
smart
To receive and download workout information from your M7i to any Bluetooth
ID number is required. The following is a one-time machine ID setup procedure. NOTE: Steps 1 through 7 must be
completed within one minute.
1
Begin with the computer off and pull
Resistance Lever all the way down
towards you. This is GEAR "1" position.
4
1x
Pedal 1 full revolution to change the
TIME value to "2".
GEAR "88"
7
6x
GEAR "1"
Shift the Resistance Lever from top
to bottom (GEAR "88" to GEAR "1")
for a total of 6 times.
*
2
1x
Pedal 1 full revolution to change the
TIME value to "1".
5
Shift the Resistance Lever down to
GEAR "19".
"SET id"
8
Upon successful completion of
Steps 1–7, "SET id" will appear on
the display. Proceed to Step 9 to
set ID number.
NOTE: If
completed
allow the computer to shut down
(estimated time one minute) and
restart the procedure.
ID NUMBER
Steps 1–7 are not
within one minute,
10
® smart * Ready device, a machine
3
Shift the Resistance Lever up to
GEAR "21".
6
1x
Pedal 1 full revolution to change the
TIME value to "3".
GEAR 17 to 24
9
INCREASES
GEAR 8 to 16
ID number
HOLDS
ID number
GEAR 1 to 7
DECREASES
ID number
Move the Resistance Lever up to
increase, or down to decrease, the ID
number setting to any value between
1 and 199. Hold the ID number by
positioning the Resistance Lever to
any GEAR number between 8 and
16. Allow the computer to shut down
(estimated time one minute).
NOTE: The computer must shut down
to save and exit the Bluetooth
setup mode.
® smart *