Keiser M7i Installation And Operation Manual page 9

M7i WHEELCHAIR-ACCESSIBLE TOTAL BODY TRAINER
LEVELER FOOT
The M7i should be placed on a level surface. If the sub-floor is not level, the Leveler Foot allows adjustment to a
position that will level your M7i.
Adjust the Leveler Foot by slightly lifting the right base
corner of the M7i and screwing the foot in or out, refer to
Figure 5.
•
Rotate the Leveler Foot in (counterclockwise, from a
topside view) to drive the foot further into the base.
•
Rotate the Leveler Foot out (clockwise, from a topside
view) to extend further out of the base.
Set the base corner down and test for stability. The M7i
should sit flat without rocking. Adjust and fine-tune the
Leveler Foot as needed.
NOTE: The M7i should not be used until it is level. If the
M7i is moved to a different location, adjust the Leveler
Foot as needed to level your M7i.
PROPER OPERATION CHECK
Before operation of the M7i, check to ensure that:
•
Left and Right Recoilers are installed correctly.
•
Recoiler Safety Straps draw out/in freely without
snag.
•
Computer Display cycles on within the first full
revolution of the Footpads.
If all assembly requirements have been met, and you have read and understood the Important Safety
Instructions, test ride the M7i under the supervision of a spotter. Adjust and fine-tune as needed.
WARNING: Failure to perform final check for proper operation prior to normal use of the M7i will void
your warranty and could result in serious injury.
It is recommended that the M7i is pedaled in a forward rotation.
Figure 5. Leveler Foot Adjustment
•
M7i is properly leveled.
•
The Adjustment Knobs properly engage the Handle
position holes and are hand-tight.
•
Wipe down the M7i using a clean cloth.
09