Save & Exit Setup / Exit Without Saving - Acorp 4D533 User Manual

MAINBOARD BIOS SETUP
☆ To set a password:
1.You must first set the Supervisor password by choosing Supervisor Password and pressing
[ENTER]. Setup prompts for a password.
2. Enter a 1-8 character password using letters, numbers, or a combination of both. The
specific characters are not shown as you enter them. Press [ENTER].
3. A confirmation box appears asking you to re-enter the password. Enter the password again.
Press [ENTER] Follow the same procedure to set the User Password.
☆ Changing a Password:
Select the appropriate password option (Supervisor or User) from the main menu and press
[ENTER]. Enter the current password and press [Enter]. The screen does not display the
characters entered. Enter in the new password, then the confirmation. You cannot change the
current password unless you know it.
☆ Erasing a Password:
1. If you know the current password, but want to disable password checking, follow the
procedure for changing the password. When Setup prompts for the new password, simply
press [ENTER]. You will see a message indicating that the password is disabled.
2. If you do not know the current password, the CMOS must be cleared by cleared by the Clear
CMOS jumper (Refer to page 14). *This will clear all user-defined BIOS Setup options.
3.14 Save & Exit Setup / Exit Without Saving
Select Save & Exit Setup to save into the CMOS memory all modifications specified during the
current session. To save the configuration changes, highlight this option in the main menu and
press [ENTER]. The system displays a confirmation message on the screen. Press the Y key
and then [Enter]. Press the N key and then the [Enter] key to abort. The Exit Without Saving
option allows the user to exit the BIOS Setup without updating any changes made during the
current session.
User's Manual
55