Acorp 4D533 User Manual page 52

MAINBOARD BIOS SETUP
☆ Resources Controlled By
Default setting is "Auto (ESCD)". This setting allows the BIOS to self detect setting and
Plug-and-Play devices during start up. The user can select and configure IRQs under
"Manual" mode.
When set to Manual, you are able to configure the IRQ and DMA Resources. Pressing
<Enter> at the selection field brings up a submenu like the one shown below:
CMOS Setup Utility - Copyright ( C ) 1984 - 1999 Award Software
IRQ-3 assigned to
IRQ-4 assigned to
IRQ-5 assigned to
IRQ-7 assigned to
IRQ-9 assigned to
IRQ-10 assigned to
IRQ-11 assigned to
IRQ-12 assigned to
IRQ-14 assigned to
IRQ-15 assigned to
↑ ↓ → ←: Move
F1: General Help
☆ IRQ3/4/5/7/9/10/11/12/14/15 assigned to
By default, all resources are assigned to the PCI Bus. If an ISA card requires a particular IRQ,
those resources should be set to Legacy ISA so that the PCI Bus will not try to use them.
Choices are Legacy ISA and PCI/ISA PnP.
Pressing <Enter> at DMA Resources brings up a submenu that gives you the following
options:
52
IRQ Resources
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
PCI Device
Enter: Select +/-/PU/PD: Value
F5: Previous Value F6: Fail-Safe Defaults
User's Manual
Item Help
Menu Level >
Legacy ISA for devices
compliant with the
original PC AT bus
Specification, PCI/ISA
PnP for devices
Compliant with the
Plug and Play standard
Whether designed for
PCI OR ISA bus architecture
F10: Save ESC: Exit
F7: Optimized Defaults