Table of Contents
Advertisement
HAREWARE INSTALLATION
☆ USB Connectors
This mainborad supports (Black color) 4 USB devices. If the USB port connectors on the rear
panel are inadequate, three USB headers are available for additional USB port connectors.
The header labeled USB complies with the Universal Serial Bus (USB) 1.1 specification.
Connect the bundled 2-port USB connector set to this header and mount the USB bracket to
an open Slot in the chassis. The other two USB headers comply with USB 2.0 specification
that supports up to 480 Mbps connection speed. This speed advantage
over the conventional 12 Mbps on USB 1.1 allows faster Internet connection, interactive
gaming, and simultaneous running of high-speed peripherals. These headers support the next
generation USB peripherals such as high resolution cameras, scanners, and printers.
26
USB Port Description
PIN
SIGNAL
1
Vcc
2
-Data 0
3
+Data 0
4
GND
5
Vcc
6
-Data 1
7
+Data 1
8
GND
User's Manual
DESCRIPTION
+5V
Negative Data Channel 0
Positive Data Channel 0
Ground
+5V
Negative Data Channel 1
Positive Data Channel 1
Ground
The Cable from the
USB connector
bracket hooks to
the USB header
on the mainboard.
These two connectors
permit connection of
two USB peripheral
devices directly to the
system.
Advertisement
Table of Contents
