Table of Contents
Advertisement
MAINBOARD BIOS SETUP
☆ HDD Power Down
This instructs hard drives to shut off while in the Power Management modes.
☆ Soft-Off by PWR-BTTN
When set to "Delay 4 Sec", the power button has a dual function where pressing less
Than 4 seconds will place the system in sleep mode and shut down the system when
The button is held more than 4 seconds. "Instant-Off", the system will be shut down
right away when the power button is pressed.
☆ Wake-Up by PCI & LAN
If your PCI card supports PME (Power Management Event) signal and this item is set
as Enabled, PCI peripherals drive PME signal to wake the system from low-power
States S1-S5.
☆ Power On by Ring
The option lets you specify enable or disable external Modem Wake Up function. It
power up the computer when modem receives a call while the computer is in
Soft-off mode.
Note: The computer cannot receive or transmit data until the computer and pplication
are fully running. After the item is set as Enabled system must enter to peration
System once before system is turned off.
☆ CPU Thermal-Throttling
Set the percent of power consumption when CPU over heat.
☆ Resume by Alarm
Set this option to enable or disable the RTC Alarm to Wake Up the system which is set
at soft Off.
☆ Date (of Month) Alarm, Time (hh:mm:ss) Alarm
Set these options to specify the RTC Alarm time on Date / Hour / Minute / Second.
☆ Primary/Secondary IDE 0/1, FDD, COM, LPT Port & PCI PIRQ [A-D]#
These items enable or disable the detection of IDE, floppy, serial, parallel port and PCI PIRQ
[A-D] activities for power down state transition. Actually it detects the read/write to/from I/O
port.
50
User's Manual
Advertisement
Table of Contents
