Power Led Connections - Acorp 4D533 User Manual

HAREWARE INSTALLATION

2.2.7 Power LED Connections

System Function Connector Block (J6)
☆ Pins [ 2 & 4 & 6 ] Power LED lead
Pins 2 & 4 & 6 connect to the power LED from the system's case.
☆ Pins [ 3 & 4 & 5 & 6 ] Speaker
Connects to the Speaker lead from the systems case.
☆ Pins [ 8 & 10 ] Suspend LED lead
This LED blinks to indicate the system is in suspend mode.
☆ Pins [ 11 & 12 ] IDE Activity LED
Hook the IDELED lead to this connector, with the RED lead corresponding to Pin-1.
☆ Pins [ 13 & 14 ] Reset switch lead
Connects to the Reset Switch lead from the system's case. The reset switch is used to
cold-boot t the system without actually turning off the power, reducing wear and tear on
the power supply.
☆ Pins [ 15 & 16 ] Soft Power Switch
Connects to the Power Switch featured on ATX case designs. This switch must be
hooked up before the system can be powered on.
Note: Under the following two conditions, you have to press and hold the switch for longer
than4 seconds to power off your system, regardless of the Soft-Off by PWRBTN setting
in the BIOS.
■ Shortly after the system is powered on, when the BIOS message is not yet appear.
■ When CPU hangs.
User's Manual
21